Email:[email protected]
0

Shopping Cart

  • No products in the cart.
Great Lakes 4-Diffuser Manifold
  • Home
  • Great Lakes 4-Diffuser Manifold

Warning: Undefined array key 0 in /www/wwwroot/petpalacelux.com/wp-content/themes/Closet-260825/woocommerce/content-single-product.php on line 58
Great Lakes 4-Diffuser Manifold

Great Lakes 4-Diffuser Manifold

In Others
$257.28 $128.64

SKU: HD9833939935
Availability: In stock

Great Lakes 4-Diffuser ManifoldAll are self-weighted and include a plastic underlay that prevents sediment erosionThe diffusers included as part of the ALP4 assembly are made of glass-bonded silica, are virtually indestructible and will give many years of service.The diffuser manifold comes with a polyethylene underlay to prevent the disturbance of sediments. The manifold is attached to the underlay with twopolyethylene cable ties (included).Assembly Instructions1. Remove all items from the package to make sure you have the following:One (1) PVC Diffuser Manifold with 3/8″ Barb AdapterFour (4) Sweetwater Glass-Bonded Silica Diffusers (ALR8M)One (1) Polyethylene UnderlayTwo (2) 111/2″ Plastic Cable Ties2. Completely submerge the four diffusers in water. Take them out and hold them upside down to let any residue from the manufacturing process drainout. Repeat until the water leaving the diffusers is clear.3. Screw the four diffusers into the manifold finger tightDO NOT OVERTIGHTEN.4. Place the manifold with the diffusers in the center of the polyethylene underlay.5. Use the two cable ties to secure the manifold to the underlay. Cut off excess tie.6. The ALP4 assembly can then be connected to the air line tubing and lowered into the water.Maintenance of Air DiffusersThe only maintenance normally required for Sweetwater air diffusers is periodic cleaning. The frequency of cleaning will be determined by the mineral andorganic content of the water in which the air diffusers are used. In clean, cold, soft water, cleaning may only be necessary every 2 or 3 years. In very hardwater or water high in organics, it could be necessary as often as every 2 months.1. Remove from service and blow out excess water. If fouled with barnacles or other gross foreign material, scrape or hose off.2. If you have a 1/2″ NPT white fitting on the end of your diffuser, then immerse the diffuser portion, not the fitting, in undiluted muriatic acid for a sufficienttime to dissolve the clogging material. This may take from one minute to eight hours in the most extreme cases. Be very careful when using acid! Weareye, face and hand protection and have clean water available for rinsing and acid diluting in the case of an acid splash or spill.3. After the clogging material has been dissolved, rinse thoroughly before reuse.4. Discard the used acid after reducing its strength to a neutral pH by diluting with at least ten times as much water as acid. Add acid to water; never addwater to acid.

Related Products

BIO BALE ( White) 1 gal. - CPR Aquatics
$14.95 $11.96
+
JBJ Arctica 1/10 HP Titanium Aquarium Chiller DBA-75
$765.98 $147.00
+
IM AUQA Gadget - High Tide Water Riser - Desktop
$9.60 $7.68
+
Aqua Ultraviolet VIPER 400W UV Sterilizer, Stainless Steel Housing, 2" Outlets, With Flow Switch, 110V
$4,023.79 $148.00
+